این دستگاه، وسیله ایست مناسب جهت افراد مبتدی و علاقمند به موج! با هزینه ای بسیار کم صاحب یک دستگاه با دو کاربرد می شوید: تستر رنج گسترده ای از قطعات و همچنین یک اسیلوسکوپ با صفحه نمایش رنگی- این دستگاه می تواند اولین ابزار افراد آماتور در آزمایشگاه الکترونیکشان یا یک دستگاه همراه جهت تست قطعات بدون نیاز به حضور در آزمایشگاه باشد
محصولات مرتبط
ماژول فست شارژ مدل QC3-4P
ماژول فست شارژ مدل QC3-1P
ماژول بلوتوث مدل M28
Main functions
:Digital oscilloscope
Passbands: 200 kHz
Mixing frequency: 2.5 MS/sec
Input resistance: 1 MΩ
The range of input stresses with a divider of 1:1 : 80Vp ($i40V)
The range of input stresses with a divider of 1:10 : 800Vp ($400V)
Sensitivity vertically: 10mV/Div — 10V/Div
Horizontal sweep: 10us/Div — 500s/Div
Sync Modes: Auto/Normal/Single
Timing Type: Signal Edge, Signal Fall
Synchronization level: Custom, with indica
Oscillogram freezing: HOLD function
Automatic Measurements: Maximum, Minimum, Average, RMS, Peak-to-Peak, Frequency Meter, Period Length, Courtesy
Generator of test Shemi signal
Generator Shim signal in oscilloscope mode: frequency from 0 to 80 kHz, respectability 0...100%, amplitude 5V
Test signal generator in component tester mode: from 1.5 kHz to 10 MHz
TESTER of electronic components
Checking transistors and measuring their parameters : Transmission coefficient Hfe; Direct voltage Base-Emitter; Ratio of Collector current to emitter current; ICEO, ICES, direct voltage of the built-in protection diode
Inspection of diodes: Direct pressure drop across the diode, junction capacitance, reverse leakage current
JFET field-effect transistors: gate capacitance Cg, drain current at a fixed gate current, voltage drop across the protective diode
IGBT transistors : Drain current at a fixed gate current, voltage drop across the protective diode
MOSFET transistors : Turn on Vt; Capacitance of the gate Cg; voltage drop on the protective diode
Checking capacitors : Measurement of vessels from 25pF to 100uF; Loss factor Vloss
Checking resistors : Measuring resistance from 0.01 Ohm to 50 MΩ
Inductance coil testing Measurement of inductance from 10uH, measurement of DC coil resistance
Battery check : Charge measurement in the range 0.01V — 4.5V, Battery polarity indication
Temperature measurement using the DS18B20 sensor
Humidity measurement using the DHT1 sensor
Decoding of signals from IR remote control NEC remote control: Display of user codes and data codes, display of infrared sensor signal waveform
Basic technical characteristics
Model: SO-TC2
Display: TFT display with a diagonal of 2.5 inches and LED backlight
Power source: Built-in lithium ion battery with a capacity of 1500 mAh
Charging port: USB TYPE C voltage +5V
دیدگاه خود را بنویسید